How To: Print Barcode / QR Code in the XtraReport.
This article describes the process of Barcode or QR Code printing in the XtraReport.
Pre-requisites
GinesysReportDesigner.exe must be present in the Shared Location at HO. For example, if Ginesys is installed in C: drive then you can find the GinesysReportDesigner.exe in the following location: C:\GSL\GINESYS12\Shared\GinesysReportDesigner.exe
Step-by-step guide
- Go to Ginesys HO application shared folder (C:\GSL\GINESYS12\Shared) and run 'GinesysReportDesigner.exe' application.
- Go to File > Open.
- Select the existing REPX file.
- You can see that the layout has been populated in the Designer area.
Go to Property Grid > Data > XML Data Path.
Select the data source (XML file) collected from the store.
- Take Barcode from Standard Controls.
Set Symbology as per your requirement (Code39/Code93/Code128/QR Code).
- Set Expression from field list as per your requirement. It is recommended to use Auto-module to show proper Barcode.
- If the field contains special characters, then set CompationMode = Byte in the Barcode properties.
- Now the Barcode and the QR Code can print in the XtraReport.